ADC CLI Commands

arpparam

The following operations can be performed on “arpparam”:

unset show set

unset arpparam

Use this command to remove arpparam settings.Refer to the set arpparam command for meanings of the arguments.

Synopsis

unset arpparam [-timeout] [-spoofValidation]

show arpparam

Display the global setting of dynamically learned ARP entries.

Synopsis

show arpparam

Arguments

Output

timeout The ARP table entry aging time, in seconds.

spoofValidation enable/disable arp spoofing validation

Example

show arpparam

set arpparam

Sets a global time-out value for dynamic ARP entries.

Synopsis

set arpparam [-timeout ] [-spoofValidation ( ENABLED DISABLED )]

Arguments

timeout Time-out value (aging time) for the dynamically learned ARP entries, in seconds. The new value applies only to ARP entries that are dynamically learned after the new value is set. Previously existing ARP entries expire after the previously configured aging time. Default value: 1200 Minimum value: 5 Maximum value: 1200

spoofValidation enable/disable arp spoofing validation

Possible values: ENABLED, DISABLED Default value: DISABLED

Example

set arpparam -timeout 200 -spoofvalidate ENABLE

arpparam