ADC CLI Commands

rise-param

The following operations can be performed on “rise-param”:

set show unset

set rise param

Sets the global parameters for RISE NOTE: This command is deprecated.

Synopsis

Arguments

directMode RISE Direct attach mode

Possible values: ENABLED, DISABLED Default value: ENABLED

indirectMode RISE Indirect attach mode

Possible values: ENABLED, DISABLED Default value: DISABLED

Example

set riseParam -directMode ENABLED

show rise param

Display the global parameters for RISE NOTE: This command is deprecated.This is deprecated as Rise is not supported

Synopsis

Arguments

Output

directMode RISE Direct attach mode

indirectMode RISE Indirect attach mode

Example

show riseParam

unset rise param

Use this command to remove rise param settings.Refer to the set rise param command for meanings of the arguments.NOTE: This command is deprecated.

Synopsis

rise-param