ADC CLI Commands

router-ospf

June 28, 2023

Contributed by:

The following operations can be performed on “router-ospf”:

show router ospf

Display the state of the OSPF daemon. NOTE: This command is deprecated.All routing configurations have now been moved to vtysh

Synopsis

Arguments

ospfoptions The Router OSPF option. Use this option to display one of border-routers, database, interface, neighbor, route, and virtual-links.

Possible values: border-routers, database, interface, neighbor, route, virtual-links

Output

network The network on which OSPF is running.

netmask Netmask of the network on which OSPF is running

Example

show ospf neighbor

unset router ospf

Unset the OSPF parameters that were configured using the ###set ospf### command..Refer to the set router ospf command for meanings of the arguments.NOTE: This command is deprecated.All routing configurations have now been moved to vtysh

Synopsis

Example

unset ospf -router-id

set router ospf

Configure different OSPF parameters. NOTE: This command is deprecated.All routing configurations have now been moved to vtysh

Synopsis

Arguments

routerID The router ID.

passiveInterface The mode of the Interface. Use this option to change the mode of the interface to listen only.

staticRedistribute The state of the router in redistributing static routes. Use this option to enable the redistribution of static routes.

staticMetricType The metric type for static routes. Default value: 2 Minimum value: 1 Maximum value: 2

kernelRedistribute The state of the router in redistributing kernel routes. Use this option to enable the redistribution of kernel routes.

kernelMetricType The metric type for kernel routes. Default value: 2 Minimum value: 1 Maximum value: 2

conRedistribute The state of the router in redistributing connected routes. Use this option to enable the redistribution of connected routes.

conMetricType The metric type for connected routes. Default value: 2 Minimum value: 1 Maximum value: 2

learnRoute The state of the router in learning routes from OSPF. Use this option to enable route learning from OSPF.

network The broadcast network on which OSPF is to be run.

netmask The netmask for the broadcast network.

area The area ID of the area in which OSPF is running. Default value: -1

host The stub link.

cost The cost of the hostroute.

Example

set ospf -routerID 1.2.3.4

The official version of this content is in English. Some of the Cloud Software Group documentation content is machine translated for your convenience only. Cloud Software Group has no control over machine-translated content, which may contain errors, inaccuracies or unsuitable language. No warranty of any kind, either expressed or implied, is made as to the accuracy, reliability, suitability, or correctness of any translations made from the English original into any other language, or that your Cloud Software Group product or service conforms to any machine translated content, and any warranty provided under the applicable end user license agreement or terms of service, or any other agreement with Cloud Software Group, that the product or service conforms with any documentation shall not apply to the extent that such documentation has been machine translated. Cloud Software Group will not be held responsible for any damage or issues that may arise from using machine-translated content.

Was this helpful

router-ospf

June 28, 2023

Contributed by:

June 28, 2023

Contributed by:

router-ospf

show router ospf

Synopsis

Arguments

Output

Example

unset router ospf

Synopsis

Example

set router ospf

Synopsis

Arguments

Example

In this article