cs-parameter¶
The following operations can be performed on "cs-parameter":
unset cs parameter¶
Use this command to remove cs parameter settings.Refer to the set cs parameter command for meanings of the arguments.
Synopsis¶
unset cs parameter -stateupdate
set cs parameter¶
Sets the status of the state update parameter for the server. By default, the content switching virtual server is always UP, regardless of the state of the load balancing virtual servers bound to it. This command enables the virtual server to check the status of the attached load balancing server for state information.
Synopsis¶
set cs parameter -stateupdate ( ENABLED | DISABLED )
Arguments¶
stateupdate Specifies whether the virtual server checks the attached load balancing server for state information.
Possible values: ENABLED, DISABLED Default value: DISABLED
Example¶
set cs parameter -stateupdate (ENABLED|DISABLED)
show cs parameter¶
Show CS parameters
Synopsis¶
show cs parameter
Arguments¶
Output¶
stateupdate Specifies whether the virtual server checks the attached load balancing server for state information.
builtin Flag to determine if CS param is built-in or not
feature The feature to be checked while applying this config
Example¶
show cs parameter