Skip to content

filter-htmlinjectionparameter

The following operations can be performed on "filter-htmlinjectionparameter":

unset| show| set|

unset filter htmlinjectionparameter

Removes the HTML injection settings..Refer to the set filter htmlinjectionparameter command for meanings of the arguments.NOTE: This command is deprecated.Deprecated in favour of Client Side Measurements that can be enabled on an appflow action

Synopsis

Example

a) unset htmlinjectionparameter -rate b) unset htmlinjectionparameter -frequency c) unset htmlinjectionparameter -rate -frequency

show filter htmlinjectionparameter

Displays the HTML injection parameters. NOTE: This command is deprecated.Deprecated in favour of Client Side Measurements that can be enabled on an appflow action

Synopsis

Arguments

Output

rate For a rate of x, HTML injection is done for 1 out of x policy matches.

frequency For a frequency of x, HTML injection is done at least once per x milliseconds.

strict Searching for tag. If this parameter is enabled, HTML injection does not insert the prebody or postbody content unless the tag is found.

htmlsearchlen Number of characters, in the HTTP body, in which to search for the tag if strict mode is set.

builtin Flag to determine if html injection param is built-in or not

feature The feature to be checked while applying this config

Example

rate:10

set filter htmlinjectionparameter

Sets the HTML injection parameters. NOTE: This command is deprecated.Deprecated in favour of Client Side Measurements that can be enabled on an appflow action

Synopsis

Arguments

rate For a rate of x, HTML injection is done for 1 out of x policy matches. Default value: 1 Minimum value: 1

frequency For a frequency of x, HTML injection is done at least once per x milliseconds. Default value: 1 Minimum value: 1

strict Searching for tag. If this parameter is enabled, HTML injection does not insert the prebody or postbody content unless the tag is found.

Possible values: ENABLED, DISABLED Default value: ENABLED

htmlsearchlen Number of characters, in the HTTP body, in which to search for the tag if strict mode is set. Default value: 1024 Minimum value: 1

Example

set htmlinjection parameter -rate 10 -frequency 1

Was this article helpful?