ptp

The following operations can be performed on "ptp":

set| show|

set ptp

Specifies whether to use Precision Time Protocol (PTP) to synchronize time across cluster nodes. This command is applicable in a cluster setup only. If you do not want to use PTP, you must disable PTP, by using this command, and instead enable NTP.

Synopsis

set ptp -state ( DISABLE | ENABLE )

Arguments

state Enables or disables Precision Time Protocol (PTP) on the appliance. If you disable PTP, make sure you enable Network Time Protocol (NTP) on the cluster.

Possible values: DISABLE, ENABLE Default value: ENABLE

show ptp

Displays the status of Precision Time Protocol (PTP) on the appliance.

Synopsis

show ptp

Arguments

Output

state Enables or disables Precision Time Protocol (PTP) on the appliance. If you disable PTP, make sure you enable Network Time Protocol (NTP) on the cluster.