Skip to content

cloud-parameter

The following operations can be performed on "cloud-parameter":

show| set| unset|

show cloud parameter

Displays information about cloud parameters

Synopsis

show cloud parameter

Arguments

Output

ControllerFQDN FQDN of the controller to which the Citrix ADC SDProxy Connects

ControllerPort Port number of the controller to which the Citrix ADC SDProxy connects

InstanceID Instance ID of the customer provided by Trust

CustomerID Customer ID of the citrix cloud customer

ResourceLocation Resource Location of the customer provided by Trust

ControlConnectionStatus Status of the control connection: In case of successful registration to the controller, connection status will be shown as "Registered" else "Unregistered".

Deployment Describes if the customer is a Staging/Production or Dev Citrix Cloud customer

connectorResidence Identifies whether the connector is located Onprem, Aws or Azure

set cloud parameter

Set the cloud parameters required to register to the cloud.

Synopsis

set cloud parameter [-ControllerFQDN ] [-ControllerPort ] [-InstanceID ] [-CustomerID ] [-ResourceLocation ] [-activationCode ] [-Deployment ] [-connectorResidence ]

Arguments

ControllerFQDN FQDN of the controller to which the Citrix ADC SDProxy Connects

ControllerPort Port number of the controller to which the Citrix ADC SDProxy connects Minimum value: 1

InstanceID Instance ID of the customer provided by Trust

CustomerID Customer ID of the citrix cloud customer

ResourceLocation Resource Location of the customer provided by Trust

activationCode Activation code for the NGS Connector instance

Deployment Describes if the customer is a Staging/Production or Dev Citrix Cloud customer

Possible values: Production, Staging, Dev

connectorResidence Identifies whether the connector is located Onprem, Aws or Azure

Possible values: None, Onprem, Aws, Azure, Cpx

unset cloud parameter

Unset the cloud parameters.Refer to the set cloud parameter command for meanings of the arguments.

Synopsis

unset cloud parameter [-InstanceID] [-CustomerID] [-ResourceLocation]

Was this article helpful?