Skip to content

lldp-param

The following operations can be performed on "lldp-param":

set| show| unset|

set lldp param

Sets the global Link Layer Discovery Protocol (LLDP) parameters such as LLDP Timer, Hold Time Multiplier, and LLDP mode.

Synopsis

set lldp param [-holdtimeTxMult ] [-timer ] [-Mode ]

Arguments

holdtimeTxMult A multiplier for calculating the duration for which the receiving device stores the LLDP information in its database before discarding or removing it. The duration is calculated as the holdtimeTxMult (Holdtime Multiplier) parameter value multiplied by the timer (Timer) parameter value. Default value: 4 Minimum value: 1 Maximum value: 20

timer Interval, in seconds, between LLDP packet data units (LLDPDUs). that the Citrix ADC sends to a directly connected device. Default value: 30 Minimum value: 1 Maximum value: 3000

Mode Global mode of Link Layer Discovery Protocol (LLDP) on the Citrix ADC. The resultant LLDP mode of an interface depends on the LLDP mode configured at the global and the interface levels.

Possible values: NONE, TRANSMITTER, RECEIVER, TRANSCEIVER

Example

set lldpparam -mode RECEIVER

show lldp param

Display the global LLDP params

Synopsis

show lldp param

Arguments

Output

holdtimeTxMult A multiplier for calculating the duration for which the receiving device stores the LLDP information in its database before discarding or removing it. The duration is calculated as the holdtimeTxMult (Holdtime Multiplier) parameter value multiplied by the timer (Timer) parameter value.

timer Interval, in seconds, between LLDP packet data units (LLDPDUs). that the Citrix ADC sends to a directly connected device.

Mode Global mode of Link Layer Discovery Protocol (LLDP) on the Citrix ADC. The resultant LLDP mode of an interface depends on the LLDP mode configured at the global and the interface levels.

Example

show lldpparam

unset lldp param

Use this command to remove lldp param settings.Refer to the set lldp param command for meanings of the arguments.

Synopsis

unset lldp param [-holdtimeTxMult] [-timer] [-Mode]

Was this article helpful?