Skip to content

vrIDParam

The following operations can be performed on "vrIDParam":

unset| set| show|

unset vrIDParam

Use this command to remove vrIDParam settings.Refer to the set vrIDParam command for meanings of the arguments.

Synopsis

unset vrIDParam [-sendToMaster] [-helloInterval] [-deadInterval]

set vrIDParam

Sets global parameters of VMACs on the Citrix ADC.

Synopsis

set vrIDParam [-sendToMaster ( ENABLED | DISABLED )] [-helloInterval ] [-deadInterval ]

Arguments

sendToMaster Forward packets to the master node, in an active-active mode configuration, if the virtual server is in the backup state and sharing is disabled.

Possible values: ENABLED, DISABLED Default value: DISABLED

helloInterval Interval, in milliseconds, between vrrp advertisement messages sent to the peer node in active-active mode. Default value: 1000 Minimum value: 200 Maximum value: 1000

deadInterval Number of seconds after which a peer node in active-active mode is marked down if vrrp advertisements are not received from the peer node. Default value: 3 Minimum value: 1 Maximum value: 60

Example

set vrIDParam -sendToMaster ENABLED

show vrIDParam

Displays the VRID global settings on the Citrix ADC.

Synopsis

show vrIDParam

Arguments

Output

sendToMaster Forward packets to the master node, in an active-active mode configuration, if the virtual server is in the backup state and sharing is disabled.

helloInterval Interval, in milliseconds, between vrrp advertisement messages sent to the peer node in active-active mode.

deadInterval Number of seconds after which a peer node in active-active mode is marked down if vrrp advertisements are not received from the peer node.

Was this article helpful?