Skip to content

smpp-param

The following operations can be performed on "smpp-param":

set| unset| show|

set smpp param

Modifies the SMPP parameters on the Citrix ADC.

Synopsis

set smpp param [-clientmode ] [-msgQueue ( ON | OFF )] [-msgQueueSize ] [-addrton ] [-addrnpi ] [-addrrange ]

Arguments

clientmode Mode in which the client binds to the ADC. Applicable settings function as follows: * TRANSCEIVER - Client can send and receive messages to and from the message center. * TRANSMITTERONLY - Client can only send messages. * RECEIVERONLY - Client can only receive messages.

Possible values: TRANSCEIVER, TRANSMITTERONLY, RECEIVERONLY Default value: TRANSCEIVER

msgQueue Queue SMPP messages if a client that is capable of receiving the destination address messages is not available.

Possible values: ON, OFF Default value: OFF

msgQueueSize Maximum number of SMPP messages that can be queued. After the limit is reached, the Citrix ADC sends a deliver_sm_resp PDU, with an appropriate error message, to the message center. Default value: 10000 Minimum value: 0

addrton Type of Number, such as an international number or a national number, used in the ESME address sent in the bind request. Default value: 0 Minimum value: 0 Maximum value: 256

addrnpi Numbering Plan Indicator, such as landline, data, or WAP client, used in the ESME address sent in the bind request. Default value: 0 Minimum value: 0 Maximum value: 256

addrrange Set of SME addresses, sent in the bind request, serviced by the ESME. Default value: "\d*"

unset smpp param

Use this command to remove smpp param settings.Refer to the set smpp param command for meanings of the arguments.

Synopsis

unset smpp param [-clientmode] [-msgQueue] [-msgQueueSize] [-addrton] [-addrnpi] [-addrrange]

show smpp param

Displays the SMPP parameters configured on the Citrix ADC.

Synopsis

show smpp param

Arguments

Output

clientmode Mode in which the client binds to the ADC. Applicable settings function as follows: * TRANSCEIVER - Client can send and receive messages to and from the message center. * TRANSMITTERONLY - Client can only send messages. * RECEIVERONLY - Client can only receive messages.

msgQueue Queue SMPP messages if a client that is capable of receiving the destination address messages is not available.

msgQueueSize Maximum number of SMPP messages that can be queued. After the limit is reached, the Citrix ADC sends a deliver_sm_resp PDU, with an appropriate error message, to the message center.

addrton Type of Number, such as an international number or a national number, used in the ESME address sent in the bind request.

addrnpi Numbering Plan Indicator, such as landline, data, or WAP client, used in the ESME address sent in the bind request.

addrrange Set of SME addresses, sent in the bind request, serviced by the ESME.

Was this article helpful?