Citrix Virtual Apps and Desktops SDK

Reset-BrokerEnabledFeatureList

June 30, 2023

Contributed by:

Resets the broker’s list of enabled features.

Syntax

Reset-BrokerEnabledFeatureList [-AdminClientIP <String>] [-AdminAddress <String>] [-BearerToken <String>] [-TraceParent <String>] [-TraceState <String>] [-VirtualSiteId <String>] [<CommonParameters>]

<!--NeedCopy-->

Detailed Description

The Reset-BrokerEnabledFeatureList cmdlet resets the broker’s list of enabled features.

Toggling site features on or off doesn’t become effective immediately. There will typically be a delay as the changes are propagated across the site based on the scheduling of refresh logic built into the controllers.

After toggling features on or off you can run Reset-BrokerEnabledFeatureList to ensure that the broker can access the new list of enabled features immediately.

Each broker service instance holds its list of enabled features. In order for the feature list changes to be applied immediately throughout the XenDesktop site this command needs to be run on every controller in the site.

Parameters

Name	Description	Required?	Pipeline Input	Default Value
AdminClientIP	Internal use only.	false	false
AdminAddress	Specifies the address of a XenDesktop controller that the PowerShell snapin will connect to. This can be provided as a host name or an IP address.	false	false	Localhost. Once a value is provided by any cmdlet, this value will become the default.
BearerToken	Specifies the bearer token assigned to the calling user	false	false
TraceParent	Specifies the trace parent assigned for internal diagnostic tracing use	false	false
TraceState	Specifies the trace state assigned for internal diagnostic tracing use	false	false
VirtualSiteId	Specifies the virtual site the PowerShell snap-in will connect to.	false	false

Input Type

None

You cannot pipe input into this cmdlet.

Return Values

None

Examples

Example 1

C:\PS> Reset-BrokerEnabledFeatureList

<!--NeedCopy-->

Description

Reset the broker’s list of enabled features.

The official version of this content is in English. Some of the Cloud Software Group documentation content is machine translated for your convenience only. Cloud Software Group has no control over machine-translated content, which may contain errors, inaccuracies or unsuitable language. No warranty of any kind, either expressed or implied, is made as to the accuracy, reliability, suitability, or correctness of any translations made from the English original into any other language, or that your Cloud Software Group product or service conforms to any machine translated content, and any warranty provided under the applicable end user license agreement or terms of service, or any other agreement with Cloud Software Group, that the product or service conforms with any documentation shall not apply to the extent that such documentation has been machine translated. Cloud Software Group will not be held responsible for any damage or issues that may arise from using machine-translated content.

Was this helpful

Reset-BrokerEnabledFeatureList

June 30, 2023

Contributed by:

June 30, 2023

Contributed by:

Reset-BrokerEnabledFeatureList

Syntax

Detailed Description

Related Commands

Parameters

Input Type

None

Return Values

None

Examples

Example 1

Description

In this article