Citrix Virtual Apps and Desktops SDK

Reset-BrokerEnabledFeatureList

Resets the broker’s list of enabled features.

Syntax


Reset-BrokerEnabledFeatureList [-AdminAddress <String>] [-BearerToken <String>] [-TraceParent <String>] [-TraceState <String>] [-VirtualSiteId <String>] [<CommonParameters>]

<!--NeedCopy-->

Detailed Description

The Reset-BrokerEnabledFeatureList cmdlet resets the broker’s list of enabled features.

Toggling site features on or off doesn’t become effective immediately. There will typically be a delay as the changes are propagated across the site based on the scheduling of refresh logic built into the controllers.

After toggling features on or off you can run Reset-BrokerEnabledFeatureList to ensure that the broker can access the new list of enabled features immediately.

Each broker service instance holds its list of enabled features. In order for the feature list changes to be applied immediately throughout the XenDesktop site this command needs to be run on every controller in the site.

Parameters

Name Description Required? Pipeline Input Default Value
AdminAddress Specifies the address of a XenDesktop controller that the PowerShell snapin will connect to. This can be provided as a host name or an IP address. false false Localhost. Once a value is provided by any cmdlet, this value will become the default.
BearerToken Specifies the bearer token assigned to the calling user false false  
TraceParent Specifies the trace parent assigned for internal diagnostic tracing use false false  
TraceState Specifies the trace state assigned for internal diagnostic tracing use false false  
VirtualSiteId Specifies the virtual site the PowerShell snap-in will connect to. false false  

Input Type

None

You cannot pipe input into this cmdlet.

Return Values

None

Examples

Example 1


C:\PS> Reset-BrokerEnabledFeatureList

<!--NeedCopy-->

Description

Reset the broker’s list of enabled features.

Reset-BrokerEnabledFeatureList